Ordered 17.06, the seller sent 20.06 The samara region came 26.06. I liked the radio. The sound is excellent-really when watching a movie like in a movie. Adapter for the antenna, as it was said, no. To the radio immediately took the dvr. The rear camera has its own, a new one has not been connected. Packed was good. Took for 11400 at a discount of the seller
Everything became without refinement (did not sag anything). Where to choose the car and did not find, but everything works (even sees the light on or not on the canbus). The first impressions are positive. I want to repeat.
The radio is great. Installed on the restyling mazda. Everything rose as a native, nor did i sag, the wires did not change in places (as they write below). In the settings, choose your car and the buttons on the steering wheel begin to work (here everything is written in detail and shown: www.sp.teyes.ru). The picture is cool, at any viewing angle, the sensor response is normal, the sound is not worse, it is a little different, but cool. Gps antennas and 4g signal catch perfectly. Built-in memory was 64 gb, instead of the declared 16 gb, a pleasant surprise. I installed myself, without any special skills, everything is quite easy and simple, in time took forty minutes. In general, the purchase is satisfied. I recommend!
The radio tape recorder is gorgeous!!! She came in safe. In the kit put a screwdriver as a gift. Quality is fine. Everything works and does not buggy. The seller is very responsible. Answered all questions and correctly understood the essence of the question!!! I recommend to everyone!!!
It came relatively quickly. With the installation had to get mad. Cx 7 2008. The frame had to bite nobly, as it did not look like holes. Very strange working buttons on the steering wheel. Connected for the first time-the buttons are not determined. On the advice of comments changed the places of wires in can bus and the effect of zero. Another comment bit the gray wire and connected it with key1. After that, the buttons earned, but at the same time no information on the onboard computer was issued. In the settings chose the machine. This is done through settings-factory settings-enter the password 1686699 (as in the video from the site) and choose the brand model and type can bus. After that, the onboard computer began to show signs of life. Returned all sawing and wires back (as from the factory). The buttons began to work in full. Then suddenly stopped working. In order that they re-earned had to change the cutting of wires again (key1 did not connect) started the machine. Onboard and buttons do not work. Returned all back and all norms When manipulating with the radio (connected the camera), the buttons on the steering wheel fell off again. I had to repeat the procedure again. When connecting the camera need both red lead pull to + reversing lamp. Option, when other chinese radio can simply power everything from the backlight of the number will not roll. The camera will always be on. Assembled at first in this way and at the engine plant immediately switched to the reverse mode. You can't close this menu. I had to redo it.